![]() After you connect click Remote -> Displays -> Use Retina Resolution.Make sure you're connecting from a Mac with a Retina display and make sure the remote Mac also has support for retina.Make sure you're running Jump Desktop Connect 6.7.65 beta on the host.At the moment only supported when connecting from a Mac with a retina screen to another Mac with a retina screen. New: Retina mode for Fluid connections.Fixes for playing audio through Bluetooth headphones. ![]() Open up Jump Desktop -> Preferences -> General -> Connections New: Options to always start connections in 'Observe Only' mode and turn of Fluid's resolution matching for all connections.On the remote / host mac, the audio will play on the Jump Desktop Microphone device.After you connect click Remote -> Audio -> Send Audio and select a local device to start recording from.Make sure you're running Jump Desktop Connect 6.7.65 beta.At the moment this supported when connecting from a Mac to another Mac. You can now send audio to the machine you're connecting to. New: Microphone redirection support for Fluid connections.Fix for regression in 8.8.22 with 'Fullscreen on all displays'.Fixes for full screen display problems on macOS 12 Monterey.Fixed: Shortcuts stop working in multi-display fullscreen mode.Fixed: Fullscreen shortcut not working on Monterey.Fixed: Fullscreen display fixes when windows go fullscreen in the same space.I even tried an older flash, to get them back, but of course, 4.03-back were incompatible with my video card. Judging by memory and the BIOS pictures in the original manual, TYAN has been slowly confiscating BIOS settings (especially with regard to memory). You are indeed correct I happened to have an ASUS nForce 2 system set up for a friend, and it clearly states "will not play w/ECC." System just goes into a non-POST, one beep "loop."Īlright, as for the MPX yes, I have tried it all by itself (not to mention in various assorted slots of the MPX's four)-no dice-4 beeps and no POST.ĢX (256MB) Corsair CMX250A-3500LLPT (current) If the above was already tested, or fails, please give me more details of your setup and I'll try it out here to see if I can find something. Did you install the TWIX1024RE-3200LLPT alongside the old RAM? If you did, remove them and install only the TWINX RAM.Īs fortune would have it, I too have the Tyan MPX and some of the same RAM available. I would just like to point out, that if that KT8 motherboard you are refering to is the MSI motherboard, then I can tell you now that the RAM you have bought (TWINX1024RE-3200LLPT) will not work with that board.Īs for your current problem with the Tyan MPX. What have I done? Is it something I can change in jumpers (i.e., voltage)? If there's no resolution, what ARE the specs I should have been watching when I attempted the upgrade? Any help is appreciated. Although my current CMX256A-3500C2PT works just fine, the TWINX just gives me 4 beeps and a blank screen. ![]() As I wanted to upgrade my mem from 512K to 1GB, I assumed I could purchase the TWINX1024RE-3200LLPT, use it on my MPX for the time being, then move it to the KT8 when the time (re: $$$) was right. I currently own a TYAN Tiger MPX mobo, but intend to switch to an Opteron/KT8 combo in the near future. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |